How to Change Configuration Register Settings on Cisco Router

The configuration register can be used to change Cisco Router behavior in different ways like How Router boots ?, Router booting process and Console speed etc. Find some examples below to change the configuration register settings on Cisco Router. Find Cisco Router Default Configuration Register value  The factory-default setting for the configuration register is 0×2102. This indicates that the router should attempt to load a Cisco IOS® software image from Flash memory and load the startup configuration with a console speed of 9600 baud. With show version command you can view the current setting of the configuration register: Cisco-Router#sh version

How to recover or break the Cisco Router password

In below article I described  how to recover or break the enable password and the enable secret password. These passwords protect access to privileged EXEC and configuration modes. The enable password  can be recovered, but the enable secret password is encrypted and must be replaced with a new password. Use the procedure described in this document in order to replace the enable secret password. To recover or break the forgotten old password on Cisco Router or Switch we should bypass the original configuration when Router boots up and we have to enter the privileged mode without password. Then we load original configuration into RAM from NVRAM, configure a new password and save things back to the NVRAM with original boot sequence. The following configuration procedure is applicable for any Cisco router, such as 800, 2600, 3600, 1800, 2800, 3800 etc. 1. Cisco Router Password Recovery Procedure : 1. Connect the Cisco […]

Download VPN Client for 64bit Windows Vista/ Windows 7

Cisco VPN Client is supported to x32 windows machines only and not supported on x64 windows machines (XP 64, Vista 64 or Windows 7 64bit). The solution is either using XP compatibility mode in windows – which consumes resources OR using  a compatible VPN client and good to know that it’s free! The Shrew Soft VPN Client for Windows is a free IPsec Remote Access VPN Client for Windows 2000, XP and Vista operating systems ( x86 and amd64 versions) Unix, FreeBSD, NetBSD and Linux based operating systems provides compatibility for VPN appliances produced by vendors such as Cisco, Juniper, Checkpoint, Fortinet, Netgear, Linksys, Zywall and many others…                       Download Download Shrew Soft VPN Client for Windows   Download Shrew Soft VPN Client for Linux and BSD