RSSAll Entries in the "Channelized E1/T1" Category

Troubleshoot Slip Secs Errors on Cisco Controller T1 Interfaces

We will find Slip Secs Errors on Controller T1 interfaces in Cisco Routers. If slips are present on the T1 line means there is a clocking problem from Telco provider. The Customer Premises Equipment (CPE) will need to synchronize to the clocking from the T1 provider (Telco). Cisco#show controllers t1 T1 0/0/0 is up. Applique type is Channelized T1 Cablelength is long 0db No alarms detected. alarm-trigger is not set Soaking time: 3, Clearance time: 10 AIS State:Clear LOS State:Clear LOF State:Clear Version info FPGA Rev: 08121917, FPGA Type: PRK4 Framing is ESF, Line Code is B8ZS, Clock Source is Line. CRC Threshold is 320. Reported from firmware is 320. Data in current interval (255 seconds elapsed): 0 Line Code Violations, 0 Path Code Violations 12 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins 0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, […]

Most Useful Channelized E1 and Channelized T1 Configuration Commands

Most Useful Channelized E1 and Channelized T1 Configuration Commands Table of Contents Channelized E1 and Channelized T1 Setup Commands autodetect encapsulation cas-group (controller e1) cas-group (controller t1) channel-group clear controller clock source (controller) clock source (Cisco AS5200) controller cpp authentication cpp callback accept description (controller) description (interface) dialer outgoing dialer voice-call encapsulation cpp framing interface serial isdn answer1, isdn answer2 isdn caller isdn calling-number isdn fast-rollover-delay isdn incoming-voice data isdn not-end-to-end isdn sending-complete isdn switch-type linecode loopback (controller) loopback local (controller) loopback local (interface) loopback remote (controller) loopback remote (interface) map-class dialer pri-group show controllers e1 show controllers t1 show interfaces serial bchannel show isdn   Channelized E1 and Channelized T1 Configuration Commands This chapter describes the function and displays the syntax for channelized E1 and channelized T1 setup commands. For more information about defaults and usage guidelines, see the corresponding chapter of the┬áDial Solutions Command Reference. autodetect encapsulation To […]